Modification of Brush Device
The center pair of the flat label brush is positively labeled and both sides are symmetrical. The brush is perpendicular to the surface of the container. The overlapping gap of the brush sweep container is: a single brush is 10mm ~ 15mm, and a combination brush is 5mm ~ 10mm. The position of the cleaning brush from the sponge is 1mm ~ 2mm. The adjustment of the bottle head. The bottle head should be 20 mm lower when there is no bottle than when there is a bottle.
Adjustment of tab boxes
When the plane labeling machine is used, the central line of the marking box, the central axis of the marking station are tangent to the label paper, and the central axis of the marking plate is arranged in a line at three points. The marking plate is tangent to the label paper(0 distance), and the marking box is moved closer to 1mm. ~ 2mm can be. The gap between the marking box and the pressure strips on both sides should be between 0.8 mm and 1mm. Too large a gap causes the marking paper to shift in the marking box and there is an oblique mark. Too small a gap will cause poor push. The adjustment of the position of the scratch hook of the standard box: The scratch hook of the upper and lower sides is on the same vertical plane and is evenly struggling with the standard paper. Tags supply the adjustment of the roller: When there is no label, the tab press can press to the front of the Zui of the tab box and is equipped with a label, the tag hook means that the nearby label can not be crushed.
Adjustment of the mark station
Adjustment of scratch rubber board and rubber roll of plane sticker machine: There can be no gap between scratch rubber board and rubber roll in the whole length. If there is gap, it can be adjusted by adjusting eccentric bolt to adjust scratch rubber plate. The adjustment of the rubber roller and the rubber plate: The rubber plate and the rubber roll only contact each other without any pressure. The gap is too large, there is too much glue on the marking plate, resulting in throwing glue. The gap is too small, too tight contact, will squeeze the glue away, there is no glue on one side of the plate. Practice has shown that the gap between the plate and the roller is better than that between 0.1 mm and 0.2 mm. It can be achieved by adjusting the bearing seat of the lower part of the roller, and adjusting the upper part of the roller when necessary.